Sound Card Packet  with AGWPE

Translations of this site
Most recent AGWPE version is:  2013.415  15 Apr 2013

Introduction
Overview
Computer requirements
Packet Engine Pro

Configure AGWPE
Download and Install
Basic AGWPE Setup
2 Radio Setup
2 Card Setup

Sound Device Setup
Basic Device Settings
Rename Sound Device
Additional Settings
Using the Tuning Aid

Problems?
Program Behavior
Receiving
Transmitting
Connections
Firewalls

AGWPE Features
AGWPE on a Network
Baud Rates & Modes
Remote Control
TCP/IP Over Radio
Tips and Tricks
Traffic Parameters

Compatible Programs:
Setup Help

Radio Interface
Getting Started
Kits and Pre-assembled
USB SignaLink
Receive Audio Cable
Transmit Audio Cable
PTT (TX Control) Cable
2 Radio Modification

About Packet
Packet Overview
Exchange Modes
TNCs and AGWPE
What To Do with Packet
Common Frequencies
Frame Headers
Further Reading
 

APRSISCE/32 and AGWPE

Configuring APRSISCE/32 to use AGWPE is not difficult, as Steve Daniels G6UIM helped explain.

In APRSISCE/32:

1. On the top menu, select Configure> Ports> New port.

2. In the "New RFPort" popup window, for type use the drop down menu to select AGW , and give the port a name of your choice, for example, "AGWPE VHF". Click create.

3. A "TCP/IP or Comm?" pop up window will appear. Click on "yes" to configure this port as a TCP/IP port.

4. In the next TCP Configuration pop up window, in the IP or DNS field, type in "localhost or 127.0.0.1" (assuming AGWPE is running on the same computer). For Port, enter 8000 (assuming you haven't changed the default TCP/IP port in AGWPE, which is 8000).

5. In the next "Port Configuration" popup you can enable or disable various options -- or just leave them set for their defaults. If you are running an Igate, make sure RF to IS, IS to RF,  Enabled, Xmt Enable, Beacon and Messages are all ticked.

6. Click accept and you are done.

 

Return to the "Compatible Programs" page

Last Updated:
18Aug2015

by Ralph Milnes NM5RM

 

Top of page